Assembly & Installation Instructions for the LED Aluminum Lightbox

Necessary tools for assembling and installing

Supplied materials (included):

  • 1 lightbox
  • 1 fabric print

Other necessary tools (not included):

  • Drill
  • Screwdriver
  • Screws adapted to your wall
  • Plastic anchors (for gypsum wall)

Assembly

Lightboxes come pre-assembled.

Installation

Installing the lightbox on the wall:

  1. Place the lightbox against the wall.
  2. Attach the lightbox onto the wall by fastening the screws adapted to your wall into the metal backing. For a gypsum wall, we suggest to use plastic anchors before fastening the screws to secure the frame to the wall.

Fabric Print

Mounting the fabric print in the lightbox:

  1. Take one corner of the fabric print and insert the silicone edge trim into the slot of the lightbox. Put this way each corner of the fabric print in the lightbox.
  2. Push in the central part of the silicone edge trim on each of the four sides.
  3. Finish by smoothing the perimeter of the fabric print so that the silicone is pressed evenly all over.

Note: To remove the fabric print, pull on the label for it to easily come off the lightbox.

(The parts may vary slightly from those shown in the photos due to manufacturing differences.)

Download this guide